|
|
JetWave 2450 Specification

Overview
Specifications
Ordering Information
Datasheet
|
IEEE 802.11b/g/n Wireless Outdoor AP/CPE
- IEEE 802.11n wireless outdoor solution, backward compatible with 802.11b/g
- 3 times higher throughput than 802.11b/g solution, up to 150Mbps net data rate
- High performance and low maintaining cost for the video surveillance network
- One model with both Embedded 8dbi Directional Antenna and N-Type Socket
- Up to 5KM Wireless coverage
- Wireless QoS (WMM) for video precedence transmission
- Advanced security system by WEP, WPA, WPA2 and MAC address filter
- Supports Spanning Tree Protocol, IGMP Snooping, SNMPv3
- Built-in 12VDC PoE, to be powered through Ethernet cable
- -20~70°C Operating temperature for hazardous environment application
|
| Technology |
|
IIEEE 802.11b/g and 802.11n draft for Wireless LAN
IEEE 802.11i Wireless Security
IEEE 802.3u for 10/100Base-TX
IEEE802.1D Spanning Tree Protocol
|
|
| Performance |
|
|
|
|
|
IEEE 802.11b/gn HT20 ISM Band
*FCC: 2.412 GHz ~ 2.462 GHz (CH1 ~ CH11)
*ETSI: 2.412 GHz ~ 2.472 GHz (CH1 ~ CH13)
IEEE 802.11g/n HT40 ISM Band
*FCC: 2.422GHz ~ 2.452 GHz (CH3 ~ CH9)
*ETSI: 2.422 GHz ~ 2.462 GHz (CH3 ~ CH11) |
|
|
Transmission/Emission Type: Direct Sequence Spread
Spectrum (DSSS)
Data modulation type: OFDM/BPSK/QPSK/CCK/DQPSK/
DBPSK |
|
|
FCC: (Average Output Power @ 25°C)
802.11b: 26 ± 1.5dBm
802.11g: 6-24Mbps: 26 ± 1.5dBm,
36-48Mbps: 25 ± 1.5dBm, 54Mbps: 24 ± 1.5dBm
802.11n:
HT20: 22/23/24/25/26 ± 1.5dBm (MCS7/6/5/4/0-3)
HT40: 21/22/23/25/26 ± 1.5dBm (MCS7/6/5/4/0-3)
PS: FCC band edge exclusive
ETSI(CE):
802.11b: Max. 10.5dBm
802.11g: Max. 10.5dBm
802.11n:
Max. 10.5dBm@HT20
Max. 10.5dBm@HT40 |
|
|
IEEE 802.11b: 1Mbps -93dBm, 11Mbps -88dBm
IEEE 802.11g: 6Mbps -88dBm, 54Mbps -73dBm
IEEE 802.11n
*HT 20 MCS0 -88dBm, MCS7 -70dBm
*HT 40 MCS0 -84dBm, MCS7 -67dBm |
|
|
11b: 11M, 5.5M, 2M, 1Mbps
11g: 54M, 48M, 36M, 24M, 18M, 12M, 9M, 6Mbps
11n draft:
6M, 6.5M, 13M, 13.5M, 19.5M, 26M, 27M, 39M, 40.5M,
53M, 54M, 58.5M, 65M, 78M, 81M, 104M, 108M, 117M,
121.5M, 130M, 135Mbps |
|
| Default Antenna Characteristics |
|
|
|
|
|
|
|
|
| |
Reserve N-Type Connector, switchable by SW |
|
| Interface |
|
1 x 10/100Base-T, Auto Negotiation
|
|
|
One Reset button to restore factory default
|
|
|
2/4-pair UTP/STP Cat. 5 cable (50m)
|
|
| Management |
|
Web UI, SNMP, DHCP Client, Configuration
backup/restore, JetView Protocol |
|
|
Wireless and Ethernet Traffic statistics
|
|
|
Web, Windows management tool,
TFTP, firmware backup |
|
|
Base Station, CPE, Peer to Peer,
Peer to Multiple Peer |
|
|
SSID configurable, Hide SSID, Channel
Selection, Limitation of Client connection, Wireless client
isolation, Tx Flow Control |
|
|
SSID configurable, CPU with multi-client
support, TX Flow Control by AP |
|
|
Full, 50%, 25%, 12.5%, Min |
|
|
Best or adjust target data rate |
|
|
Easy tool to discover available AP |
|
|
Self-Wireless Connection test |
|
|
802.1x, Radius Server, Access Control
by Trusted Wireless station, manually add station,
HTTPS(*), SSH(*) |
|
|
WEP 64/128/152 bits, WPA-PSK
(TKIP), WPA2-PSK(AES), Mixed WPA/WPA2 |
|
|
Spanning Tree Protocol with Fast Forwarding |
|
|
|
|
Filter the multicast stream |
|
|
|
|
Power: Green ON/OFF, Amber Blinking – Device initial
LAN: Green ON/OFF, Blinking – Sending/Receiving data
WLAN (AP mode):
Green Off – WLAN Disabled,
Green Blinking – WLAN Activity
WLAN (CPE mode):
Green Blinking – Good Quality
Yellow Blinking – Marginally Acceptable Quality
Red Blinking – Bad Quality |
|
| |
|
| Power Requirements |
|
Power over Ethernet Cable, Up to 50 meter |
|
|
Input: 100-240VAC, 0.6A 50-60Hz
Output: 12V, 1A |
|
|
Max. 12V, 900mA, depends on user volume |
|
| Mechanical |
|
|
| External Antenna connector |
|
|
|
165mm (H) x 60 mm (W) x 34 mm (D)
|
|
|
Pole Mount (ADC-12 Aluminum alloy) |
|
|
|
| Environmental |
|
|
|
|
|
|
| Regulatory Approvals |
|
FCC part 15 Subpart B&C, CE EN300 328 |
|
|
|
|
|
|
|
|
|