Korenix Launches New PCI-104 Ethernet Switch Card JetCard 2105

Taipei, Taiwan, Nov., 2008 ---Korenix releases new PCI-104 Ethernet switch card JetCard 2105, which is a flexible and high performance five-port Ethernet switch card in PCI-104 format. The PCI-104 bus of JetCard 2105 supports both +3.3V and +5V slot. The easy-to-install drivers that come with JetCard make it easier for you to set up your complex system. And with its 1.5KV Hi-pot isolation protection, and overload current/voltage protection, JetCard 2105 is ideal for industrial applications in severe environments and is your best choice for embedded networking solution. The JetCard 2105 uses Marvell 88E6065 chip to provide 5 Ethernet ports. Each Ethernet port in the JetCard offers IEEE 802.3 10 Base-T and 100 Base-Tx compliant Ethernet data transmission with auto MDI/MDI-X and auto- negotiation.

Auto MDI/MDI-X: The JetCard automatically determine whether or not it needs to interchange cable sense between pairs so that an external crossover cable is not required. If the JetCard interoperate with a device that cannot automatically correct for crossover, the JetCard makes the necessary adjustment prior to commencing Auto-Negotiation.

Flow control: The JetCard supports back-pressure and pause frame-based flow control schemes to ensure zero packet loss under temporary traffic congestion.

QoS (Quality of Service): QoS for networks is an industry-wide set of standards and mechanisms for ensuring high-quality performance for critical applications. JetCard provides the shared memory-based QoS switch architecture. Packets are directed into one of four traffic class queues based
upon Port, IEEE 802.1p, IPv4’s TOS or Diff-Serv, or IPv6’s Traffic Class.

VLAN: The JetCard supports IEEE802.1Q tag VLAN and also can be enabled on a per-port basis VLAN.

Ethernet Statistics monitoring: The JetCard has a set of thirty, 32-bit counters to provide a set of Ethernet statistics for frames received on ingress and transmitted on egress. A register interface allows the JetCard to capture, read, or clear the counter values.

Customized Configurations: The JetCard supports an add-on EEPROM for programming its internal registers. The EEPROM data will be read in once after JetCard is reset.
The PCI-104 form factor supports the PCI bus. The maximum configuration for the PCI bus of PC/104-Plus modules is four plus the Host Board.

JetCard 2105 5 Ports 10/100Mbps Fast Ethernet Switch PCI-104 Card 

• Support 32 bit PCI-104 bus
• 5 ports RJ45 Ethernet Switch
• IEEE 802.3 10 Base-T and 100 Base-Tx compatible
• Full or half duplex at 10/100 Mbps
• IEEE 802.3u Auto-Negotiation supported
• IEEE 802.1Q VLAN supported
• QoS supported
• 1.5KV Hi-pot isolation protection